What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 01:18
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Upvotes:
One
‘Smash’ abruptly announces final show after Tony Awards drama in Broadway shocker - New York Post
An AC voltage/ current source, and an ac inductive load.
First Sentence:
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
What do you think about me (Aditya Krishna)?
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
what exactly is a ‘surge’ protector?
These devices are installed between the “hot” and “neutral” and protective ground.
What’s one positive trait you’ve gained because of BPD?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Avalanche Signs Nelson - NHL.com
At least they know the answer if they wanted it.
He then describes Rainy Season and Lightning.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
There are three different concepts here that are getting confused.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Powerful solar telescope unveils ultra-fine magnetic 'curtains' on the sun's surface - Space
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
The third is lightning and “how it gets conducted into a home.”
A runway under construction at Newark's beleaguered airport reopens early - NPR
Here is a simplified AC power diagram.
In schematic diagrams this is the symbol for a fuse:
the problem then depends on "how fast does the fuse operate?".
But… the neutral is now “floating” because of the 1 ohm resistance.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
I post the exact comment here.
Edit 2024–10.
The LAX/Metro Transit Center is opening today—here’s what you need to know - Time Out
Barnstars:
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This one hit behind the barn.
A circuit breaker is similar, but is resettable.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
[image of Common-mode choke]
so, what happens?
Because the load is inductive, the current lags the voltage.(by a bit).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–16 [ OO OLAOYE OYEBODE ]
A fuse is a non-resetable over current circuit protector.
The MOV will conduct when the voltage exceeds 50% of line voltage.
It also is a device that limits the change in current flow.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
So, the voltage could go up to 500 volts, and the fuse will not open up.
He then describes the function of a fuse.
(Dc diagram shown, AC is similar).
But it can get overloaded, and no longer works.
He then asserts :
What is lightning?
It seems Mohan does not understand the difference between a comment and an Answer.
The other is “what does a “fuse” do?”
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
The bolt then partially travels down the line to your home.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
What does a fuse do?
2024–10–10[John johnson John Johnson ]
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
but I think this circuit , shows a few more pieces.
For this case there are devices called Metal oxide varistors (MOV).
This is where this question deviates from being a 'generic' question, and becomes more specific.
eight
This is where the MOV conducts again, and dissipated the energy.
but this device (an Inductor) … impedes the rapid changes in the current.
[old diagram got deleted by accident]
nine
One is “what exactly is in a ‘surge protector’ ? ”
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
There are two important concepts here.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
At one ohm, the resistor has a maximum of 1 watt power.
a photo is worth a thousand words.
This device then solves the entire problem.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This is 'the assistant's answer'
2024–10–11 [Bobby Sanchez Bobby Sanchez ].